Search found 7 matches

by antelopeslr5000
Fri Oct 13, 2017 8:10 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

Could I ask of you one more favour please? I am also after the part number for the X axis limit switch for the EGX-20. The switch seems to also be faulty.

Thanks again,
by antelopeslr5000
Thu Oct 12, 2017 10:42 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

Thank you very much Kai, greatly appreciated!
by antelopeslr5000
Wed Oct 11, 2017 11:09 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

I pulled the gear drive apart today to have a better look.

The black cover has a part number (COVER, GEAR 22025615).

Can't find a part number for the actual gear though.

Are parts still readily available for the EGX-20?
by antelopeslr5000
Sun Oct 08, 2017 11:23 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

IMG_2676.jpg
Gear Drive Pic I
IMG_2677.jpg
Gear Drive Pic II
IMG_2683.jpg
Broken Gear Drive
by antelopeslr5000
Sun Oct 08, 2017 5:47 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

So I've had a bit more of a look and I think I may have found the problem. The Y axis seems fine now, I removed the belt drive and manually moved the table down over the limit switch and the stepper motor now stops. However, the X axis has an issue. The spindle moves along the X axis for a short tim...
by antelopeslr5000
Sun Oct 08, 2017 3:25 am
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

Re: EGX-20 Table Issue

Thanks for the reply. I've had just checked the Y axis limit switch, 10.9k ohms when open and the switch closes (0 ohms) when the table passes over it so the Y axis limit switch seems fine. I'd like to give the seller the benefit of the doubt, but since they have failed to respond to any of my email...
by antelopeslr5000
Fri Oct 06, 2017 10:27 pm
Forum: Warranties & Roland Care
Topic: EGX-20 Table Issue
Replies: 10
Views: 531

EGX-20 Table Issue

Hi all, I've just purchased a EGX-20 engraver and when I first apply power, the table moves downwards but doesn't stop, it seems as it wants to keep on moving downwards beyond its physical limit. After reaching this point, it stops driving after a few seconds and I have no control any of the X, Y an...