Search found 2463 matches

by mrtn
Fri Feb 23, 2018 7:52 am
Forum: Roland VersaWorks and other Software
Topic: 2 Perf Cut Questions
Replies: 1
Views: 14

Re: 2 Perf Cut Questions

1) Versaworks will tell you any time you make changes to the print job when it needs to be re-ripped. Keep an eye open. Any other change will just register without re-rip. 2) Your cut head needs to be readjusted by your technician. It’s clearly knocked off its position. It’s a very delicate adjustme...
by mrtn
Thu Feb 22, 2018 10:05 pm
Forum: Substrates, Materials & Inks
Topic: Cleaning Fluid
Replies: 3
Views: 22

Re: Cleaning Fluid

Ohhhh, that'll be dangerous :O
by mrtn
Thu Feb 22, 2018 7:45 pm
Forum: Substrates, Materials & Inks
Topic: Cleaning Fluid
Replies: 3
Views: 22

Re: Cleaning Fluid

Yes, the all-white cartridges contain the same fluid as the manual cleaning bottle.
by mrtn
Wed Feb 21, 2018 7:00 pm
Forum: General Chat
Topic: Advice onRoland SG300 or BN-20?
Replies: 2
Views: 53

Re: Advice onRoland SG300 or BN-20?

SG-300 all day. Not even a question. It's MUCH MUCH MUCH faster and also easier to use due to open design.
by mrtn
Wed Feb 21, 2018 11:07 am
Forum: Roland VersaWorks and other Software
Topic: Moving folders to other HDD
Replies: 3
Views: 66

Re: Moving folders to other HDD

It's easier to install the whole application to the other drive.
by mrtn
Fri Feb 16, 2018 8:33 am
Forum: Warranties & Roland Care
Topic: SC545 EX display issue
Replies: 2
Views: 122

Re: SC545 EX display issue

Check the display panel cable.
by mrtn
Wed Feb 14, 2018 11:32 pm
Forum: Hardware
Topic: BN-20 dripping ink when performing perf/contour cut
Replies: 11
Views: 395

Re: BN-20 dripping ink when performing perf/contour cut

Ink pumping (klak-klak-klak) with the print carriage slightly to the left from parking spot is normal. The vacuum pump loads up the print head with ink and drains the unnecessary drips from the capping station by offseting the head and sucking the captop dry. The dirt in question may be anywhere in ...
by mrtn
Wed Feb 14, 2018 6:04 pm
Forum: Hardware
Topic: BN-20 dripping ink when performing perf/contour cut
Replies: 11
Views: 395

Re: BN-20 dripping ink when performing perf/contour cut

No master reset please!

It's either dirt or you have installed the wiper the wrong way or wrong (felt) slot.
by mrtn
Wed Feb 14, 2018 10:13 am
Forum: Hardware
Topic: Rolans sp300
Replies: 3
Views: 60

Re: Rolans sp300

Yes.
by mrtn
Tue Feb 13, 2018 8:57 pm
Forum: Hardware
Topic: Rolans sp300
Replies: 3
Views: 60

Re: Rolans sp300

What do you mean. It won’t measure the width for setup?

If you mean when printing then set your FULL WIDTH S setting in the menu to SHEET or FULL.