0mm vinyl width..

Warranties, repairs and maintenance
Post Reply
Phill Scott
Member
Posts: 1
Joined: Mon Mar 13, 2017 6:25 pm

0mm vinyl width..

Post by Phill Scott » Mon Mar 13, 2017 6:36 pm

MyRoland SP-300i has decided it cannot read the material width (it shows up as 0mm), but it does not provide any error codes. This has been happening over the last few weeks, but after re aligning and moving the pinch rollers it usually reads the width bit concerned its happening every morning now and getting harder to get it to read the width... Any help / ideas much appreciated..

User avatar
Kai Perry
Moderator
Posts: 2178
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: 0mm vinyl width..

Post by Kai Perry » Wed Mar 15, 2017 5:43 pm

The issue is down to the carriage cable, the cable and it's two guides would need to be replaced.
Kai Perry
RolandCare Advisor
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest