Page 1 of 1

VS640i media shifts

Posted: Fri Jan 12, 2018 7:40 pm
by AlexC
Hi there, when doing print and cut with artworks longer than two metres, the media moves aside then the print is not correctly aligned. Under 2 mts it would work fine, 3-4 mts length printing then the media will move away on the left hand side. I've checked the Pinch Rollers they are good. Checked the levelness of the Printer - looks pretty good.
Still the media moves apart.. Any idea??

Yours,

Alex

Re: VS640i media shifts

Posted: Mon Jan 15, 2018 10:59 am
by Kai Perry
Slow down the upspeed, this will allow the tracking to be more precise. The accuracy over 3-4 metres is improved by slowing the speed of cutting as well.

You say you have check the rollers, but check to see if the media pulls forward by hand when it is loaded.

Also try a different media, in case the media is slipping, you can test this by marking the bed and media.

Re: VS640i media shifts

Posted: Tue Jan 16, 2018 2:51 am
by AlexC
Hi Kai,

Upseed already set to 15cm/s.Will reduce it some more, I've reduce the problem considerably by adding more pressure on the pinch rollers, the media slips 0.5mm on 3m20 artwork which looks fine.
Regards,

Alex C

Re: VS640i media shifts

Posted: Tue Jan 16, 2018 8:00 am
by mrtn
Cracked/worn pinch roller frames, distorted torsion beam.

Do you by any chance leave media loaded overnight often?