had 2 questions about printing on the mpx 90

Post questions, share ideas and techniques relating to engraving and impact imaging
Post Reply
angeloangelogr
Member
Posts: 32
Joined: Fri Jun 03, 2016 1:01 pm

had 2 questions about printing on the mpx 90

Post by angeloangelogr » Fri May 26, 2017 9:17 am

Hello, was wondering if its ok when you convert to polyline to print twice over it. Ive tried it a couple times and it outlines it better but is it ok to do it? The second question is ive been printing on high resolution with 450 to 500 and the impact. I do pet tags so all words, and it seems to make it more visible. Is it ok to printat 180 -500- 500 on stainless steel and 180 -440 -440 on colored aluminum. Thank you.

User avatar
Kai Perry
Moderator
Posts: 2123
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: had 2 questions about printing on the mpx 90

Post by Kai Perry » Tue May 30, 2017 11:39 am

Normally I would use the contour output once, instead of a double print, but depending on the effect you are looking for, it is possible to do.

The settings you are using are OK, I would normally use the Roland MD setting for both.
Kai Perry
RolandCare Advisor
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

angeloangelogr
Member
Posts: 32
Joined: Fri Jun 03, 2016 1:01 pm

Re: had 2 questions about printing on the mpx 90

Post by angeloangelogr » Tue May 30, 2017 3:27 pm

Thank you for all your help.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest