Z Axis Jamming

Post questions, share ideas and techniques relating to engraving and impact imaging
Post Reply
q582gmzhi
Member
Posts: 1
Joined: Mon Feb 08, 2016 4:16 pm

Z Axis Jamming

Post by q582gmzhi » Thu Mar 17, 2016 8:48 pm

Hi,

I had an issue earlier with the Z axis jammimg when retracting.

After inspecting and cleaning I tried to manually turn the motor \ screw to get past the jam. Upon applying leverage to the screw to get the Z axis past the jam the following screw (whats left of a screw) fell from the Z Axis area. It must have been jammed somewhere and only fell out after I applied force to make the Z lift pass the jam.

It look like its off the plate in the picture with 3 holes but no screws. Can someone advise the part numbers for replacement screws.

Thanks

D...
Attachments
IMG_1389.JPG
IMG_1388.JPG
IMG_1387.JPG

User avatar
Kai Perry
Moderator
Posts: 2260
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: Z Axis Jamming

Post by Kai Perry » Wed Mar 23, 2016 2:42 pm

Which machine is this on?
Kai Perry
RolandCare Advisor
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest