Page 1 of 1

Hello

Posted: Thu May 18, 2017 10:51 am
by chrisgee
Well I though it was about time I said hello here. Have been setting up a new website for the past 9 months. Has been quite a challenge. Did the Roland training courses about 10 months ago.
Have a VS540i and have just launched the website. Sort of trying to bring print and cut to the masses !! Any feedback on website would be welcome. Hope to take an active part in these forums. I am more of a techie than a printer but have learnt a hell of a lot in the last year !

Re: Hello

Posted: Fri May 19, 2017 2:56 pm
by Joe Wigzell
Heya Chris!