Page 1 of 1

SP-300I Feed Problems?

Posted: Sat Feb 04, 2017 1:44 pm
by MacyHansen
Hi there, I am having a problem that I can not figure out! I have my material loaded on the round rollers and have it needed into the printer correctly, however after the first print job it starts feeding in uneven. I am waiting so much material.I have the locks in place next to the roll of material and I have it fed in the machine straight. Any insight?

Re: SP-300I Feed Problems?

Posted: Sat Feb 04, 2017 2:11 pm
by mrtn
Are the media flanges fixed in the core and rolling freely? Have 2 mm of space between the flanges and the guide rings. Is it happening with different media? There are some vinyls that are too tight in the rolls and sticking or distorting when unwound.

Re: SP-300I Feed Problems?

Posted: Sat Feb 04, 2017 2:15 pm
by MacyHansen
Yes they are rolling freely and have the correct space. It seems to be doing this with all material. At first I did think it was the way that they material was rolled on the core but not if it is happening with every roll.

Re: SP-300I Feed Problems?

Posted: Sat Feb 04, 2017 4:24 pm
by mrtn
Also when you give the media plenty of slack so the roll is not an issue?