BN-20 aborts job and starts blinking - connection lost

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
Post Reply
pixel
Member
Posts: 5
Joined: Fri Mar 03, 2017 10:40 am

BN-20 aborts job and starts blinking - connection lost

Post by pixel » Wed Mar 08, 2017 11:31 am

My BN-20 just stopped its job at random position, first time half of the print, second time before the cut.
(Not a matter of the material ending or something!)

What might cause that? I had to extend the USB wire, thats is the only thing that comes to my mind right now.

itfben
Bronze Member
Posts: 75
Joined: Tue Jun 14, 2016 10:34 am
Contact:

Re: BN-20 aborts job and starts blinking - connection lost

Post by itfben » Sun Mar 12, 2017 12:08 am

Long USB cables can cause a connection problem. Can you try another cable? Ideally as short as possible (e.g. 50cm rather than 2m)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest