Solenoid is not going down after print to cut

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
Post Reply
matave
Member
Posts: 2
Joined: Thu Apr 20, 2017 10:01 am

Solenoid is not going down after print to cut

Post by matave » Fri Apr 21, 2017 8:57 am

Hi all ,sorry my english i am from Mozambique - Maputo,
I am facing problem on printer XC-640 the solenoid is not going down after print to cut . But the tool carriage move to position and read the crop mark .
I changed the cable but its not moving down .
How i should solve this issue ?

Best Regards

User avatar
Kai Perry
Moderator
Posts: 2205
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: Solenoid is not going down after print to cut

Post by Kai Perry » Fri Apr 21, 2017 1:03 pm

I would look to replace the tool carriage if the cable has not resolved the problem.
Kai Perry
RolandCare Advisor
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: Baidu [Spider] and 1 guest