Page 1 of 1

Solenoid is not going down after print to cut

Posted: Fri Apr 21, 2017 8:57 am
by matave
Hi all ,sorry my english i am from Mozambique - Maputo,
I am facing problem on printer XC-640 the solenoid is not going down after print to cut . But the tool carriage move to position and read the crop mark .
I changed the cable but its not moving down .
How i should solve this issue ?

Best Regards

Re: Solenoid is not going down after print to cut

Posted: Fri Apr 21, 2017 1:03 pm
by Kai Perry
I would look to replace the tool carriage if the cable has not resolved the problem.