Good idea, thanks.

This is a follow on from my post - 'Write on Vinyls'. Some of the vinyls we use are of the 'speciality' variety which basically means, they're damned expensive and rarely available in widths usable on the BN-20!! So my question is, how can I most efficiently have the media sliced into usable widths?...

@Joe

Will be using it - was only told about it on another forum a few hours before I posted

That is an option but it would never work :) Here's what's needed: We do exactly the same thing for a client and we found a product called Digisol, that is available from Allprint. It has a textured scratch resistant finish wth a grey back adhesive and can be written on with a biro. We have printed ...

Hi guys Some while ago I made some small 'For Repair' & 'Repaired' stickers for a customer. Using a standard gloss vinyl they were next to useless an you can't write on them with a ball point pen! Today, I've been asked if I can print another lot of these stickers but on a substrate that can be writ...

I abandoned the un-cut job and started again this time perfect

At the risk of exhausting my luck ..... I'm glad to say the BN-20 just finished printing the job - it's about 3metres long BUT, although I ripped the job to 'Print & Cut', when the print finished, there was no attempt to rewind and cut!! Is there anyway I can recover this job - presently it's just s...

Yup

Sometimes I can be so DULL!!!

Well, I'm feeling rather embarrassed to say this!! I discovered I'd not fully raised the media clamp lever!! I discovered this when I just reloaded the media, all is now working. I'm not sure if the ink levels are being correctly reported - I'll check this later but I feel so relieved :) Thanks so m...

Okay, I completed all the tasks you mentioned mrtn: Switched the BN-20 Off at the rear switch. waited. Switched the BN-20 On. Removed and replaced all the cartridges. Rebooted my PC. The printer goes through its startup & cleaning cycle. Printer Status shows 'cleaning'. waited. Clicked Update. Print...