Bn20 optics connector problems

General chat that doesn't fit into other categories
Post Reply
Posts: 48
Joined: Sat Feb 27, 2016 11:42 pm

Bn20 optics connector problems

Post by BurtsBoyz » Fri Jul 07, 2017 4:49 pm

Hello all another fun question for the rubbish bn20. There is a small white electrical connector an the back of the print head that registers if there is media loaded or not basically my one keeps getting pulled out by the pinch wheels and its very hard to get back in as there is no access and the use of mirrors tweezers and a lot of time and foul language.

Does anyone else have this problem and is there a solution to this problem.

User avatar
Kai Perry
Posts: 2346
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon

Re: Bn20 optics connector problems

Post by Kai Perry » Tue Aug 01, 2017 4:22 pm

If the cable hasn't been damaged then a cable tie may be needed to keep it in place, I have seen before where the cable has been ripped out and it then needs replacement.
Kai Perry
Application Engineer
Roland DG (UK) Ltd

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest