Page 1 of 1

GX500 with Versworks

Posted: Mon Nov 25, 2019 10:38 am
by Dazz82
Hi,

I have a new gx500 Camm-1PRO, I have Versaworks 5.1.1 that was dragged off a USB onto my laptop, I have installed the program and the drivers for the printer but when i go to the Add job to Queue its greyed out and i am unable to add a job.

Can someone please help me sort this out, I don't want to use the Cut studio it comes with as i have used versaworks with my old SC540 and found it really easy to use.

Thanks in advance, I have searched and can not find anything that helps.

Re: GX500 with Versworks

Posted: Tue Nov 26, 2019 5:10 pm
by Lhepworth
Hi

The GX-500 will only work with Versaworks if you have a printer set up as well. You have to load the file into the printer queue and rip it, then drag and drop it into the GX-500 queue.

If you don't have a Roland printer to install then you will have to use the Cut Studio software.

Re: GX500 with Versworks

Posted: Tue Dec 03, 2019 1:37 am
by Dazz82
Thanks for your reply.

you are 100% correct. time to get familiar with cut studio.