Hi had a new laminator yesterday(easymount 1400H)
after laminating prints and then cutting on the printer(SP540V)
what shall I set the cutting pressure at, had a look on the internet some people say 100gf to 120gf and others 220gf so not sure I know it's
trail and error just wondering if anyone new the correct pressure. using MD3 vinyl white gloss. laminate MG-305-137 metaguard gloss.
Thanks Gav.
Pressure for cutting laminator prints
-
- Member
- Posts: 8
- Joined: Thu Oct 06, 2011 10:12 am
- Location: Llandow
-
- Member
- Posts: 8
- Joined: Thu Oct 06, 2011 10:12 am
- Location: Llandow
Re: Pressure for cutting laminator prints
Ok thanks will try.
- Joe Wigzell
- Gold Member
- Posts: 768
- Joined: Thu Apr 05, 2012 9:07 am
- Location: Clevedon, North Somerset
- Contact:
Re: Pressure for cutting laminator prints
Depends on age/condition of blade/cutting strip, heat, type of vinyl/lam etc...so just do a test cut off the printed area first and adjust accordingly!
Who is online
Users browsing this forum: No registered users and 1 guest