Magnets on a LEF-20 Bed
-
- Silver Member
- Posts: 151
- Joined: Fri Jun 03, 2016 10:45 pm
- Location: South Shields, UK
- Contact:
Magnets on a LEF-20 Bed
Hallo, I design and make my own jigs, and am looking at adding some magnetic hold downs onto the bed of the printer in a jig. Is it ok to add magnetss, will it do anything funny to the print heads? Ive tried calling the office, but they are apparently not open today
Roland BN-20 (CMYKWh)
Roland Versa UV LEF-20 (CMYK Pr Wh)
HPC Laser - LS6840PRO 60W Laser cutter/engraver
HPC Laser - LS1290PRO 80W Laser cutter/engraver x3
HPC Laser - LS6090PRO 80W Laser cutter/engraver
Trotec Speedy 300 120W with JC Vision Camera system and rotary axis.
Roland Versa UV LEF-20 (CMYK Pr Wh)
HPC Laser - LS6840PRO 60W Laser cutter/engraver
HPC Laser - LS1290PRO 80W Laser cutter/engraver x3
HPC Laser - LS6090PRO 80W Laser cutter/engraver
Trotec Speedy 300 120W with JC Vision Camera system and rotary axis.
-
- Silver Member
- Posts: 151
- Joined: Fri Jun 03, 2016 10:45 pm
- Location: South Shields, UK
- Contact:
Re: Magnets on a LEF-20 Bed
Hmm, they are the 3mm rare earth ones (same as from hard drives) I was planning on using, might change the plans to use ferrous ones then. Cheers 

Roland BN-20 (CMYKWh)
Roland Versa UV LEF-20 (CMYK Pr Wh)
HPC Laser - LS6840PRO 60W Laser cutter/engraver
HPC Laser - LS1290PRO 80W Laser cutter/engraver x3
HPC Laser - LS6090PRO 80W Laser cutter/engraver
Trotec Speedy 300 120W with JC Vision Camera system and rotary axis.
Roland Versa UV LEF-20 (CMYK Pr Wh)
HPC Laser - LS6840PRO 60W Laser cutter/engraver
HPC Laser - LS1290PRO 80W Laser cutter/engraver x3
HPC Laser - LS6090PRO 80W Laser cutter/engraver
Trotec Speedy 300 120W with JC Vision Camera system and rotary axis.
Who is online
Users browsing this forum: No registered users and 1 guest