Page 1 of 1

Card cutting

Posted: Wed Aug 31, 2016 11:49 am
by CABDutch
I have just been asked by a customer if I can do invitations with an intricate cut out, ie like the laser cut card invites that are about at the moment. Is there any way I can do this on my BN20?

The problems I can see is that the card won't have a backing sheet and also the feed position of the card in the machine ready for cutting isn't consistent, does anyone know if it is feasible? TIA.

Re: Card cutting

Posted: Tue Oct 25, 2016 5:28 pm
by Kai Perry
You could setup the blade extension to cut through the card, although with the cut speed of the BN-20 cutting card may take time.

It will also cause the blade to blunt quicker than cutting vinyl and may cause damage to the Cutting Strip.