Jetbest Max 2 bulk inks
Posted: Thu May 18, 2017 10:23 pm
I started using this system about 5 months ago, and I like the ink, it is very reasonable, and works well for the applications I'm using, however.. since I switched I've had nothing but trouble with my XR-640. I didn't think about it at first, but I believe the ink is the problem, I have steady issues with the cut carriage cable binding, and bunching up, which has lead to blown servo boards (4) I currently get about 4 days of clean printing on a new set of strips on the cable card, and I've even built a retraction system to assist the cable across the bed. It seems like the ink omits an overspray that stays wet, and seemingly tacky, which makes the cable not travel in the area like it should.. Is anyone else using this ink?, and if so, seeing any of these issues?