EGX 300 spindle

Post questions, share ideas and techniques relating to engraving and impact imaging
Post Reply
Bowmere
Member
Posts: 1
Joined: Fri Nov 29, 2019 12:29 pm

EGX 300 spindle

Post by Bowmere » Fri Nov 29, 2019 2:04 pm

Hi there,

I'm using an EGX 300 in a high school to cut acrylic and mdf.
The machine has been well used, but now the spindle is starting to not run at continuous speed. It even stops completely on cuts of only .5mm
Does anyone know what might be at fault? Could there be a belt that could be slipping.
Also does anyone know where the machine could get a good service?

Any suggestions would be appreciated

Many thanks

Bowmere

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest