Engraving uneven surface

Post questions, share ideas and techniques relating to engraving and impact imaging
Post Reply
paolo8453
Bronze Member
Posts: 95
Joined: Sat Feb 25, 2012 11:27 am

Engraving uneven surface

Post by paolo8453 » Thu Feb 08, 2018 6:03 pm

At the end of my tether with this. There must be a solution to engraving uneven surfaces. By uneven I don't mean bumpy I mean a gentle variation in surface height.

What ever happened to the ZCS-1 piezo sensor?

I can't justify a new machine when this one works so well at everything else.

Looks like I might have to gut the electronics and bring it up to date with some open source kit...
Hardware: TS-400 which seems to be the same as an EGX-400/600...

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest