Page 1 of 1

Fusion 360 post-processor

Posted: Wed Jan 02, 2019 5:19 pm
by casementsigns
Is there a post-processor available for Fusion 360 to drive an MDX-500? Currently using VCarve Pro, but I've recently got a 3D printer and have started using F360 for design, would be interesting to be able to use it for the MDX as well. Thanks.

Re: Fusion 360 post-processor

Posted: Thu Jan 03, 2019 10:42 am
by Patrick Thorn
Hi this article should be helpful as HSM Works is inside Fusion 360.
viewtopic.php?f=33&t=12717&p=32970&hili ... rks#p32970

Re: Fusion 360 post-processor

Posted: Wed Jan 30, 2019 4:58 pm
by casementsigns
Thanks, I will take a look!