Page 3 of 3

Re: Engrave studio not conecting to my pc

Posted: Fri Dec 29, 2017 7:17 am
by oscarc
Was this issue resolved? I am receiving the same symptoms with our EGX-350.

troubleshooting steps:
1. tried different ports on PC (usb is used for keyboard, mouse, and flash drive)
2. uninstall/reinstall drivers and software
3. rebooting both PC and engraver
4. tried connecting to a different PC (there is no plug/unplug usb windows tone)
5. tried different cables including the serial connection.
6. set I/O mode to <SERIAL>, <USB>, and <AUTO> respectively with no changes.

The engraver does not show up in device manager either. I am able to control the engraver via the ps/2 controller.

Re: Engrave studio not conecting to my pc

Posted: Fri Dec 29, 2017 10:04 am
by mrtn
Doesn't sound too good.

Re: Engrave studio not conecting to my pc

Posted: Tue Jan 02, 2018 10:35 am
by Kai Perry
It sounds like the mainboard may be damaged.