Page 1 of 1

Loading Dr. Engrave on an EGX-30A

Posted: Tue Feb 16, 2016 11:21 pm
by JDFay
Our company has recently purchased the EGX-30A to scribe product serial number plates. I'm still trying to load the software. I have followed the instructions and the Windows drivers seem to have loaded fine. When I click the install button for Dr. Engrave, I get the prompt from the computer asking to allow the program to be installed. I click "yes", then the prompt goes away and nothing else happens.
I'm new to this, more mechanically inclined than computer savvy, so any suggestions or help will be appreciated.

Re: Loading Dr. Engrave on an EGX-30A

Posted: Wed Feb 17, 2016 6:32 pm
by Kai Perry
You will need to install using the very latest installer for Dr Engrave. If you are based in the UK, you can raise a case with the support team who can supply you with the latest installer..

Re: Loading Dr. Engrave on an EGX-30A

Posted: Thu Feb 18, 2016 9:23 pm
by JDFay
Thanks Kai,
I am actually in the middle of the U.S. (Peoria, Illinois) The software disc included with the machine is labeled version 1.1, so I doubt it's the most recent version. Are there other online support options for acquiring the most recent installer for Dr. Engrave?

Re: Loading Dr. Engrave on an EGX-30A

Posted: Fri Feb 19, 2016 10:21 am
by Kai Perry
You should be able to get the latest installer from the US offices