MDX-40A and SRP questions

Post questions, share ideas and techniques relating to 3D prototyping and milling
Post Reply
Posts: 1
Joined: Thu Jul 05, 2018 12:44 pm

MDX-40A and SRP questions

Post by PaulDF » Thu Jul 05, 2018 12:49 pm

I have several questions re: the MDX-40A, or more precisely, the SRP software. It’s a great machine but there are a few things I just cannot figure out, or find the answer to. I hope these are clear…

1. Is it possible, in SRP Player, to set roughing and smoothing toolpaths which use different tools? I mean, after loading the file and work piece etc., I cannot seem to be able to edit the toolpaths and select say 6mm rounded for roughing, then 3mm rounded for smoothing. I had expected to be able to do this, so when the machine finishes the roughing it pauses, allows for a tool change to the 3mm (ensuring the tools are the same length), then the I run the smoothing passes.

2. Is it possible to mill an object from material without leaving a “wall” of material? E.g. if I have a 100 x 100 x 20 model, the minimum material size might be 110 x 110 x 30. If I do not cut all the way through, the model is machined into a recess with a 5mm "wall" preserved on each side. Can I get the machine to remove this?

3. As the work piece needs to be larger than the model, and the model is always in the centre in the work piece (5mm excess top and bottom in the example above). Is it possible to move the bottom surface of the model to meet the bottom surface of the work piece. For a “one-sided” object with straight sides, I want to be able to mill straight down, through the entire thickness of the material.

Are there any documents aside from the basic manual I should read?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest