Page 1 of 1

MDX 40 Zero / Origin

Posted: Wed Mar 29, 2017 1:24 pm
by qwarks
I crashed my MDX 40 into the workpeice, i hit the emergency switch and all went well, no damage.

The problem is that the machine Y zero has shifted.
I have tried turning the power off and on and let the machine find the limit switches and go to origin but the Y axsis is still 2-3 mm off.

How do i get the machine to go back to the original zero at the end of the limit switches?

Re: MDX 40 Zero / Origin

Posted: Fri Mar 31, 2017 9:43 am
by Kai Perry
It is likely the belt has slipped and would require an engineer to adjust it or calibrate the machine.