Page 1 of 1

PNC2500

Posted: Wed May 10, 2017 11:52 am
by Marcbu
Hi Is anyone still using the PNC2500 milling machine . If so can you tell me what computer software and operating system you are using . I have just pulled ours out of storage and the NT computer has died so looking for the best options . Thanks

Re: PNC2500

Posted: Thu May 11, 2017 9:23 am
by Kai Perry
Normally you would get the Roland software package RSP-009 with the machine which contains the Dr. Engrave, 3D Engrave and Modela software programs.