Hello

Come in and introduce yourself
Post Reply
Ash145
Member
Posts: 3
Joined: Sat Mar 24, 2018 9:23 pm

Hello

Post by Ash145 » Sat Mar 24, 2018 9:29 pm

Hi all, newbie here, hoping for some guidance and help getting my pnc2300a to engrave!.... Have been very proficient on my little imondela but can't seem to get any output from p.c to engraver...the imondela software is so much easier! Ash

User avatar
Kai Perry
Moderator
Posts: 2535
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: Hello

Post by Kai Perry » Mon Mar 26, 2018 8:53 am

Hi,

What type of cable connectivity are you using? And which version of Windows?
Kai Perry
Application Engineer
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Ash145
Member
Posts: 3
Joined: Sat Mar 24, 2018 9:23 pm

Re: Hello

Post by Ash145 » Mon Mar 26, 2018 12:56 pm

hi Kai, COM port 1 with Windows Xp. Unpated the driver to suit. ( hope this helps you) many thanks for your reply Ash

User avatar
Kai Perry
Moderator
Posts: 2535
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: Hello

Post by Kai Perry » Mon Mar 26, 2018 2:45 pm

As you are using it with a serial cable, ensure you are using a crossover serial cable (Null Modem). This should then connect correctly as long as the settings for serial are matched on both engraver and PC.
Kai Perry
Application Engineer
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Ash145
Member
Posts: 3
Joined: Sat Mar 24, 2018 9:23 pm

Re: Hello

Post by Ash145 » Mon Mar 26, 2018 3:02 pm

Hi Kai, perfect advise...all is well....many thanks.... Now the fun begins!...Ash

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest