Print - Cut going out of alignment

Post questions, share ideas and techniques related to sign-making and graphics production
Posts: 15
Joined: Wed Dec 10, 2014 8:03 pm

Re: Print - Cut going out of alignment

Post by Kal » Sat Dec 27, 2014 6:10 pm

Versaworks actually shows dancing ants out of line but .eps is not?? Re saved etc

User avatar
Gold Member
Posts: 2631
Joined: Tue Feb 14, 2012 4:37 pm
Location: Tallinn, Estonia

Re: Print - Cut going out of alignment

Post by mrtn » Sun Dec 28, 2014 4:15 am

Which application? I have seen significant cut line shifting in earlier Corel version when Colour Management was on. It helped if disabled "Apply generic CMYK profile" in Print dialogue.
Roland Dealer since 1993

ruel magtalas
Posts: 1
Joined: Tue Sep 10, 2019 1:31 am

Re: Print - Cut going out of alignment

Post by ruel magtalas » Tue Sep 10, 2019 2:26 am

Hello Kai,

I have the same problem as Nick has. When doing small graphic print-laminate-cut jobs, it's spot on, but when graphics are big about 2 meters, cut lines deviates by about 5mm or so.

I will try your suggested options below:

Hi Nick,

A few things to try.

1. Test the job on a different media, could just be the media slipping - NOT AN OPTION BECAUSE THE MEDIA IS THE SPEC OF THE CLIENT
2. Try the vacuum on full and also off. - DID THIS ONE
3. Check the media calibration is set to printer and is set correctly. CHECKED ON THIS AND IT SET CORRECTLY
4. Perform the print and cut adjust for feed and environment match. PERFORMED THIS AND IS SET

I will let you know how it goes. But would you happen to have update on the fix?

Thank you,

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests