bn 20 error

Post questions, share ideas and techniques relating to promotional and corporate gift production
Post Reply
rodrigoriera
Member
Posts: 8
Joined: Sun Jul 19, 2020 10:43 pm

bn 20 error

Post by rodrigoriera » Thu Jul 30, 2020 1:22 pm

Whenever I use black garment vinyl my Roland BN20 comes up with sheet end detected error and stops cutting. I don't know if any of you guys had the same problem and what you have done to solve the problem.

User avatar
Kai Perry
Moderator
Posts: 3445
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: bn 20 error

Post by Kai Perry » Thu Jul 30, 2020 3:29 pm

Tape over the paper sensor at the rear, this isn't seeing the media.

Just remember that it is in place as if you run out of material the machine will not know and will print on the bed.
Kai Perry
Application Engineer
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

rodrigoriera
Member
Posts: 8
Joined: Sun Jul 19, 2020 10:43 pm

Re: bn 20 error

Post by rodrigoriera » Sun Aug 09, 2020 10:08 am

Thank you for the answer. How can I locate that sensor?

User avatar
Kai Perry
Moderator
Posts: 3445
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: bn 20 error

Post by Kai Perry » Mon Aug 10, 2020 8:58 am

It's located on the left at the rear, look for a small cutout of the metal platen. Ensure you remove the material to check where it is located.
Kai Perry
Application Engineer
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest