BN-20 Return to Origin Sheet End Detected

Post Reply
Posts: 24
Joined: Wed Dec 28, 2016 8:06 am

BN-20 Return to Origin Sheet End Detected

Post by Ed1971 » Sat Dec 16, 2017 4:39 am

Hi All,

I have misjudged the last amount of material and need some help. I hope it is possible.

I wish to print a second pass on transparent media so I printed the first pass with Return to Origin; however, as it finished printing and was forward feeding the end of the job, a Sheetend Error came up - "Sheet End Error Detected. Please Setup Media Again.". Is there any way of feeding this job back in and have it print the second pass over the top? I have printed crop marks but I don't think that is helpful.

I hope someone has a brainwave :)

User avatar
Kai Perry
Posts: 2839
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon

Re: BN-20 Return to Origin Sheet End Detected

Post by Kai Perry » Mon Dec 18, 2017 9:57 am

The only way would be to edge the media to the same starting point and then tape some media to the end of the sheet to extend the printed area.

To get the alignment correct point send a cut job with a small line, but remove the blade this should show you whered the print will be begin, so you can line up your print.
Kai Perry
Application Engineer
Roland DG (UK) Ltd

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests