my third attempt at a project

Show off your creations
Post Reply
User avatar
mulhearnf
Member
Posts: 5
Joined: Sat May 05, 2018 9:05 pm
Location: wigan

my third attempt at a project

Post by mulhearnf » Fri May 11, 2018 7:47 am

I'm still learning how to use the egx-360 properly....

still its much better than the first attempt (engraved way, way to deep)

1. Showing what patterns I can engrave into the letters
20180510_122440513_iOS.jpg
2.They wisely went with the engrave outline option.
20180510_125150311_iOS.jpg
3. second job, before I engrave
20180510_135105401_iOS.jpg
4. After engraving. (I need to check the levelling of the machine, one end is not engraving as deep.
20180510_142618711_iOS.jpg
Tomorrow, I get to paint the wood, before or after engraving.
(I think)

User avatar
Joe Wigzell
Gold Member
Posts: 904
Joined: Thu Apr 05, 2012 9:07 am
Location: Clevedon, North Somerset
Contact:

Re: my third attempt at a project

Post by Joe Wigzell » Fri May 11, 2018 9:08 am

Getting there!
Joe Wigzell
Academy and Creative Centre Manager
Roland DG UK Ltd
http://www.rolanddg.co.uk

MICKKOZ
Member
Posts: 1
Joined: Thu Feb 21, 2019 4:30 am

Re: my third attempt at a project

Post by MICKKOZ » Thu Feb 21, 2019 4:58 am

Is that on wood? I only got my EGX-360 recently and don't know how to use it properly yet. Is there any specific bur to use with wood ?

User avatar
Kai Perry
Moderator
Posts: 2968
Joined: Wed Aug 03, 2011 3:59 pm
Location: Clevedon
Contact:

Re: my third attempt at a project

Post by Kai Perry » Thu Feb 21, 2019 1:31 pm

The standard engraving tool or a VCarve tool would be best for wood.
Kai Perry
Application Engineer
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest