Hello Joe,
how high is the final print ?
LEF-20 Emboss!
- Joe Wigzell
- Gold Member
- Posts: 768
- Joined: Thu Apr 05, 2012 9:07 am
- Location: Clevedon, North Somerset
- Contact:
Re: LEF-20 Emboss!
Hiya,
It's a bit hard to measure accurately as it's in the middle of the plaque thing it's printed on, but around 6-7mm I think.
It's a bit hard to measure accurately as it's in the middle of the plaque thing it's printed on, but around 6-7mm I think.
Re: LEF-20 Emboss!

how does the printhead height is adjusted? Is it raised after each layer?
- Joe Wigzell
- Gold Member
- Posts: 768
- Joined: Thu Apr 05, 2012 9:07 am
- Location: Clevedon, North Somerset
- Contact:
Re: LEF-20 Emboss!
The machine will not auto adjust, however I only needed to adjust the height after every other 10-layer step to keep the height accuracy.
Re: LEF-20 Emboss!
Hi there!
Can you tell me about the thick of the one layer?
I think that for example: If I need exactly 0.3 mm thickness, how many layers will I need?
Can you tell me about the thick of the one layer?
I think that for example: If I need exactly 0.3 mm thickness, how many layers will I need?
- Joe Wigzell
- Gold Member
- Posts: 768
- Joined: Thu Apr 05, 2012 9:07 am
- Location: Clevedon, North Somerset
- Contact:
Re: LEF-20 Emboss!
Hi Ernest,
I am not 100% sure, will have to run some tests. The gloss/clear will have a slightly different thickness to the CMYK I think. I am not in the office for a few weeks so will have to wait unless somebody else knows the answer?
I am not 100% sure, will have to run some tests. The gloss/clear will have a slightly different thickness to the CMYK I think. I am not in the office for a few weeks so will have to wait unless somebody else knows the answer?
Who is online
Users browsing this forum: No registered users and 1 guest