SP-300V Ocassional scan motor error 0080

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
Post Reply
User avatar
Geoffhogarth
Bronze Member
Posts: 56
Joined: Sat Sep 29, 2018 8:53 pm
Contact:

SP-300V Ocassional scan motor error 0080

Post by Geoffhogarth » Fri Apr 12, 2019 10:28 am

After waiting 2 weeks for a new scan motor, machine is up and running, printing/cutting good, as it did before without any errors.

Now however, every once in a while I get the 0080 Scan Motor Overcurrent Error 2, this only happens when the print carriage is parking up. I have run linear encoder setup then linear calibration in the service menu, but it still happens once in a while, enviromental match also done.

It can happen with a very small job, or it may run a 1,5 meter job perfectly, until the print carriage is parking. I understand the error to be caused by a light load over a long time, so this does not fit with the small job at all.

When this happens, there is a clunk, sounds like carriage is trying to go too far to the right.

Any hints much appreciated.

User avatar
Geoffhogarth
Bronze Member
Posts: 56
Joined: Sat Sep 29, 2018 8:53 pm
Contact:

Re: SP-300V Ocassional scan motor error 0080

Post by Geoffhogarth » Sat Apr 13, 2019 5:42 pm

Ok, I did the LIMIT POSITION & CUT DOWN POSITION INITIALIZE and LINEAR ENCODER SETUP and all appears to be well to-day, time will tell :-)

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests