Track of print bed - LEF 12i

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
Post Reply
ubricks
Member
Posts: 3
Joined: Thu Jun 07, 2018 4:18 pm

Track of print bed - LEF 12i

Post by ubricks » Wed May 15, 2019 12:18 pm

Hello,
When lowering the print bed today, we heard a snap/crunch sound. When attempting to check height it wouldn't work at the usual setting and we noticed that the track of the print bed which holds the wire is not flat like our other printer. See photos. It still seems to be printing properly but this does not seem to be correct?

Please advise?

Thank you in advance!

Image

Image

Lhepworth
Member
Posts: 4
Joined: Fri May 04, 2018 9:59 am

Re: Track of print bed - LEF 12i

Post by Lhepworth » Thu May 16, 2019 12:46 pm

Hi, Further to our conversation we will send an engineer out to inspect the machine for you.

Kind Regards,

Laura Hepworth
Laura Hepworth
RolandCare Adviser
Roland DG (UK) Ltd
http://www.rolanddg.co.uk

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests