MDX - 20 X-Axis not working

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
Post Reply
WilliamFurman
Member
Posts: 1
Joined: Wed Nov 30, 2016 9:08 am

MDX - 20 X-Axis not working

Post by WilliamFurman » Wed Nov 30, 2016 9:17 am

My MDX-20 has been set-up and running in its current location, but I have not used it in a couple months. When I went to use the machine and got to the layout phase in Modela the head would move along the Z and the Y, but would not move along the X an it is stuck against the far right side of the cutting area. Is there a a way I can test this before I begin the process of taking parts out to test them?

adamfromayr
Member
Posts: 22
Joined: Tue Apr 25, 2017 7:51 pm

Re: MDX - 20 X-Axis not working

Post by adamfromayr » Sun Sep 08, 2019 7:06 pm

hi did you fix this isuue? i also have the same issue?>?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest