BN-20 Printhead replacement

Need advice on using your Roland Hardware.
Please note we do not give engineering advice in this group
TDR
Member
Posts: 15
Joined: Fri Aug 19, 2016 1:23 pm

Re: BN-20 Printhead replacement

Post by TDR » Fri Jun 15, 2018 2:15 pm

Didn't. Just installed and printed. All fine.

Willdesr
Member
Posts: 1
Joined: Fri Jul 27, 2018 2:54 am

Re: BN-20 Printhead replacement

Post by Willdesr » Fri Jul 27, 2018 2:55 am

Did you have to change anything else with the print head? Was it really just plug and play? No alignment, etc...?

TDR
Member
Posts: 15
Joined: Fri Aug 19, 2016 1:23 pm

Re: BN-20 Printhead replacement

Post by TDR » Fri Jul 27, 2018 10:54 am

I didn't change any part other than the head at the time. Ran the alignment checks and adjustments from the BN-20 utility and had to do a few prints and head cleans to get some ink flowing.

User avatar
mrtn
Gold Member
Posts: 2631
Joined: Tue Feb 14, 2012 4:37 pm
Location: Tallinn, Estonia

Re: BN-20 Printhead replacement

Post by mrtn » Fri Jul 27, 2018 2:10 pm

You might get lucky with the printhead fixing in the correct position but you need to enter the head rank (the long number on the package and sticker) or you'll run the printhead with suboptimal settings.
Roland Dealer since 1993
facebook
instagram

TDR
Member
Posts: 15
Joined: Fri Aug 19, 2016 1:23 pm

Re: BN-20 Printhead replacement

Post by TDR » Fri Jul 27, 2018 4:22 pm

But you can still do it.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest