Post questions, share ideas and techniques relating to promotional and corporate gift production
4 posts • Page 1 of 1
Hi there, I am having a problem that I can not figure out! I have my material loaded on the round rollers and have it needed into the printer correctly, however after the first print job it starts feeding in uneven. I am waiting so much material.I have the locks in place next to the roll of material and I have it fed in the machine straight. Any insight?
Are the media flanges fixed in the core and rolling freely? Have 2 mm of space between the flanges and the guide rings. Is it happening with different media? There are some vinyls that are too tight in the rolls and sticking or distorting when unwound.
Yes they are rolling freely and have the correct space. It seems to be doing this with all material. At first I did think it was the way that they material was rolled on the core but not if it is happening with every roll.
Who is online
Users browsing this forum: No registered users and 0 guests